Installation

Hiverly Baseboard

All hives can be classed under two setups; Vertical or Horizontal. Because of this, the system needs to be installed slightly different depending on the type of hive you run.

Before you get started simply confirm your setup:

  • Vertical
  • Horizontal

Then, install your system in a few simple steps:

Important: Close off all existing entries and seal any large gaps with a tight mesh or all weather tape.

Remove existing hive off hive stand.

Position the unit on the hive stand.

Place the hive back on top of the unit.

Strap down and secure your hive.

Temporarily remove frames from the hive.

Cut an entry hole in the floor.

Undermount the unit to the hive.

Replace the frames and close the lid.

That’s it! and yes, it really is that simple!